|
|
|
 Now, if that team were to split...would it be dividing by zero? - Karibou [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Now, if that team were to split...would it be dividing by zero? - Karibou [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#16
12-12-2007, 19:04
|
|||||
|
|||||
|
Re: Need help with bumpers
We used blocks of abs that were mounted to the back of the plywood with some machine screws. They fit into 2x1 aluminum tubing we welded onto the side of the chassis and then we drilled a hole vertically through it all and held it in with a clevis pin and a hairpin cotter pin. For the front and back, we drilled 2 holes that the pins went through, so the pin took the place of the bolt. Looked cleaner and was easier to remove for doing maintenance and inspection. Didn't have any problems and it held it nice and snug.
Last edited by Jeff K. : 12-12-2007 at 22:26. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I need help with plastics | mechanicalbrain | Technical Discussion | 13 | 14-06-2006 11:15 |
| Need help with my code | jaywion | Programming | 9 | 20-03-2004 11:32 |
| Need help with beacons | magical hands | Programming | 2 | 11-02-2004 21:48 |
| hey need some help with writing a code please help me here | magical hands | Programming | 9 | 01-01-2004 21:46 |
| Need help with C++ | Tton | Programming | 7 | 04-11-2003 19:15 |
Threaded Mode