|
|
|
 Many software problems can be solved by plugging wires in. - Eric Finn [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Many software problems can be solved by plugging wires in. - Eric Finn [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
14-12-2007, 23:34
|
||||
|
||||
|
Re: Plate Thickness
We've been using the same design on 548's robots for the past few years. We use 3/16" plates connected with 1/2" dia spacers with 1/4-20 countersunk bolts with the thread tapped right in the spacer. We refer to the setup as clockwork spacers.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lexan side panel thickness? | Billfred | Technical Discussion | 10 | 15-01-2007 13:55 |
| Frame tubing wall thickness | sanddrag | Technical Discussion | 5 | 03-06-2005 11:04 |
| Fiberglass Thickness | archiver | 2000 | 1 | 23-06-2002 22:53 |
| Thickness of aluminium bars | Randy_Ai | Technical Discussion | 1 | 04-02-2002 20:09 |
| gear thickness | zarb | Technical Discussion | 10 | 26-01-2002 22:07 |
Threaded Mode