|
|
|
 When in doubt, ask... don't assume (unless you don't mind wasting time/money). - Bill Gold [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| When in doubt, ask... don't assume (unless you don't mind wasting time/money). - Bill Gold [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
calibration question
I am a bit confused as to how calibration of the camera is handled. We use Labview to calibrate the camera's color options, as well as define min/max values for tracking. Then we upload these settings to the camera. However, upon looking at kevin watson's code, I noticed that you can change the color tracking settings with Track_Color().
So I would like to know, if I set the color values in LabView, do I need to run Track_Color() from the RC? Or is all of my calibration data stored on the camera itself? If I am way off here, please correct me! Thanks! -Jordan |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera Calibration | itsme | Programming | 9 | 16-01-2007 15:15 |
| Gyro Calibration | gnirts | Programming | 1 | 17-02-2006 08:44 |
| Victor Calibration | railerobotics | Electrical | 11 | 16-01-2006 18:24 |
| Camera Calibration | organgtool | Programming | 0 | 11-01-2006 23:56 |
| Gyro Calibration | roboticsjenkins | Programming | 11 | 21-02-2005 20:39 |
Threaded Mode