Setting up a new shop - Chief Delphi

This is what happens when a couple of whackos get an idea at 2 am. - Rich Kressly [more]

		Chief Delphi > Technical > Technical Discussion
Setting up a new shop

Thread Tools

Rate Thread

Display Modes

#24

18-12-2007, 12:29

Dick Linn

Registered User

no team (Synergy)

Join Date: Jan 2003

Rookie Year: 2001

Location: Midlothian, VA

Posts: 679

Dick Linn has a reputation beyond repute

Re: Setting up a new shop

Over on PracticalMachinist.com, there are a number of references to "Mr. Slammy", an "operator encouragement stick". Turns out, it's a 3 pound lump hammer (drilling hammer). Apparently it was occasionally launched at apprentice machinists who crashed expensive machines.

__________________
Richard Linn

Proud father of Marine LCpl. Karl R. Linn
Co-founder Team 975
KIA, Iraq 1/26/2005

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mobile Machine Shop Equipment for new Hawaii Regional	Alan Ing	Technical Discussion	10	10-06-2007 13:48
setting camera	sbwprotoss9	Technical Discussion	0	17-01-2006 21:05
Setting up a webcam	D.J. Fluck	Chit-Chat	1	08-09-2003 01:32
Choosing a machine shop (Re: How important is a machine shop	archiver	2001	9	24-06-2002 04:20

All times are GMT -5. The time now is 18:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.