Drill Motors - Chief Delphi

...if the penalties were not significant and match-deciding then there would not be much incentive to pay attention to them, would there? - dtengineering [more]

		Chief Delphi > Old Forum Archives > 1999
Drill Motors

Thread Tools

Rate Thread

Display Modes

23-06-2002, 22:53

archiver

Forum Archival System

#0047 (ChiefDelphi)

Join Date: May 2001

Location: Pontiac, MI

Posts: 21,214

Comment from Forum Historian...

Posted by Joe Johnson, Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.

Posted on 5/5/99 8:15 PM MST

In Reply to: Drill Motors posted by Tom Vanderslice on 5/3/99 8:56 PM MST:

The following link has the info on how to take those nasty no-back pins out of those drill transmissions.

Good Luck.

Joe J.

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is Off HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Complete Drill, Seat, and Window motors for trade	archiver	2000	0	23-06-2002 22:16
Complete Drill, Seat, and Window motors for trade	archiver	2000	0	23-06-2002 22:16
Blowing drill motors	archiver	2000	6	23-06-2002 21:58
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
what about the drill motors?	Ken Leung	Motors	2	26-06-2001 02:11

All times are GMT -5. The time now is 22:14.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.