|
|
|
 a robot can always be your girl. xcept for the fact you need to share - greencactus3 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| a robot can always be your girl. xcept for the fact you need to share - greencactus3 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
22-12-2007, 23:07
|
|||||
|
|||||
|
Re: Better CMUcam2 Mount
I think the main issue it that, while a ribbon cable would bend pretty easily in the up-down direction. But getting it to twist so you can do the panning motion.. I think that would be a good bit more difficult.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Surface mount components | [527]phil | Electrical | 9 | 07-01-2006 20:24 |
| Stuck on Camera Mount | busterblade16 | Programming | 2 | 14-02-2005 22:07 |
| Camera Mount? | AnkurG | Electrical | 3 | 14-01-2005 09:26 |
| Plastic Motor Mount? | indieFan | Motors | 3 | 15-01-2004 00:03 |
| Motor mount designs | archiver | 2001 | 1 | 23-06-2002 22:40 |
Threaded Mode