Tally of Working IR Boards

[Richard McClellan]

Originally Posted by Aarnat

The Robo-Lion's (2199) IR board doesn't work.

The board turn's on an the error LED turns on. When we try to program it ( giving it power after holding down the program button and holding the button for 2 seconds as indicated by the manual), the LED turn's on (and then off when we release the button), but doesn't flash to indicate that it is ready to program. The error LED doesn't flash to indicate that there is a problem at all, but there is obviously a problem if it can't program. Several people have tryed to getting it to work but no sucess. We think it is a defective one, but if you know otherwise tell me.

Thanks,
Aarnat

The instructions are a little bit confusing - the error LED will "blink off," then one second later, the CMD0 LED comes on. So, you shouldn't be expecting the error LED to come back on like a "full blink cycle" or anything like that. Is your CMD0 LED coming on 1 second after you release the PRGM button? Just don't be expecting the error LED to come back on again after it goes off....