|
|
|
 If all you've seen of an event is the three days of the competition, you've missed 99% of the work that made it happen. - Madison [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If all you've seen of an event is the three days of the competition, you've missed 99% of the work that made it happen. - Madison [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Making your own composite parts: looking for tips
Yes, I should have mentioned that I was looking for the core material; the carbon-fiber goes on the outside, with a lightweight core on the inside. I'm looking for the core material. Aircraft use this stuff, and we could go out and buy this stuff for $100 or so a sheet; I'm looking for bargain prices, things like home insulation material, or other stuff that's cheap.
Steel would not be a good core, unless it was honeycomb material, so it would be light. But I think that stuff is pretty expensive. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HELP any tips for making promotional videos | efoote868 | Fundraising | 3 | 19-07-2006 23:19 |
| looking for motor or servo tips | Dbell5555 | Technical Discussion | 7 | 22-05-2005 18:28 |
| Making My Own Computer | Ryan Dognaux | Chit-Chat | 14 | 02-12-2004 00:51 |
| Looking for a link.. Autocad parts. | mike325 | Inventor | 1 | 09-01-2003 20:47 |
| Making your own gearbox? | ChaosMonkey | Motors | 15 | 25-05-2002 11:07 |
Hybrid Mode
