AM Super Shifters

[MrForbes]

Originally Posted by Mr. Odlies

On your site there is just the right front and rear left.

You have to hold a mirror up to your monitor to see the other two wheels.

(or maybe there's a mirror thingy in the cad software?)

[Mr. Odlies]

Originally Posted by squirrel

You have to hold a mirror up to your monitor to see the other two wheels.

(or maybe there's a mirror thingy in the cad software?)

wow, lol. Ya inventor has a mirror feature that i use a lot.

[Ed Sparks]

FYI,

I've posted most of the AndyMark gears in the FirstCadLibrary. My versions of these parts are more photo and weight realistic. I put these together so I can evaluate the effects of weight reduction operations to these parts.

[ChuckDickerson]

Andy,

Will the extended SS output shaft found here: http://www.andymark.biz/am-0147.html also work on the Gen 2 Servo Shifters thus allowing the output shaft to extend outside this side plates? If so how far would it stick out past the outside of the bearing?

[JoelP]

I want to replace the output shafts with the extended output shafts but I wasn't sure how I would go about making sure the encoder wheels are in the correct location. Is there any proper way to position the encoder wheels on the output shaft accurately?

[pakratt1991]

We'll be ordering our soon (they should have already been but I think the task was pushed aside, Christmas ) We will also be planning what needs to be done to modifying them to work with the Outback Manufacturing Tank Treads, and also hopefully to decrease some of the weight

This all starts today, so I'll see what we get out of it and let ya'll know