Vex Flame finding

[Foster]

Remember, no non VEX KOP (kit of parts). We have 2 flame sensors btw

I figured if it was an event that had flames that there would be some level of slack from the "ONLY VEX KOP" rule.

1)Take the nut driver tube and cut the narrow end off. This will leave you with the wide end that just covers the sensor and about 2" of focus tube. At $4.99 each, this is not a cheap solution.

2)Take the rubber mat and wrap four turns around a 1/2" dowel. You are trying to get the little nubs to fit into the mesh. Secure with the black zips.

3)Take two or three intake rollers and using the black zips make them into a tube. Drill a 3/8" hole in the center.

Mounting is up to you.

Post a picture of what you finally do.