|
|
|
 When there appears to be something stupid wrong with a game (HPs outscoring robots, unreliable loading, autonomous that accomplishes nothing) I shouldn't complain about it. I should see it as a challenge to exploit! - Chris is me [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
05-01-2008, 19:30
|
|||
|
|||
|
Re: Wiring pressure switch
There are different kinds of pressure switches. I'm not sure what "the pressure switch" may refer to. I didn't see one in my kit. The ones I am familiar with change resistence with the load applied, the lower the resistence, the more pressure. I hook up that kind of sensor in series with a 1/4W resistor and measure the voltage accross the sensor pins with ADC. Using the datasheet information about the resistence output, I can determine the load.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pressure switch wiring question... | Transformers | Pneumatics | 11 | 16-02-2008 12:55 |
| Pressure Switch Wiring | idahorobot | Electrical | 1 | 27-01-2007 11:18 |
| Pressure Switch wiring diagram | robotjoe | Electrical | 1 | 08-02-2005 14:01 |
| Pressure Switch Wiring Question | Matthew_H | Electrical | 4 | 16-02-2004 01:25 |
| Pressure Switch Wiring Question | Matthew_H | Control System | 1 | 08-02-2004 15:28 |
Threaded Mode