Using the IR Receiver on the Robot

now now, there is no such thing as reading the manual too much. I read it every night just before I go to bed. - 663.keith [more]

		Chief Delphi > Technical > Control System
Using the IR Receiver on the Robot

Thread Tools

Rate Thread

Display Modes

06-01-2008, 01:19

LG67

Registered User

#0067

Join Date: Jan 2005

Location: Highland-MI

Posts: 5

LG67 is an unknown quantity at this point

Using the IR Receiver on the Robot

I've been looking through the forums to find info about incorporating the IR Receiver on the Robot. Here's a list of what I've found so far
IR User Guide
and the video from the Kickoff

I haven't found much info yet.
I was wondering if anybody has found a wiring diagram for the receiver board (listing replacement components) or anything else of general interest.

Also I'd like to hear what challenges and successes other teams are facing as they use the IR in test hybrid modes.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using a VEX Receiver with Non-Vex Equipment	akaria	VEX	26	06-09-2008 00:55
Using the Robot Simulation Toolkit to simulate OI Controls	JimGRobot	LabView and Data Acquisition	1	17-03-2007 04:14
Where do I begin to get the robot to move using the camera?	Ianuser	Programming	10	16-02-2007 17:55
Running the robot using Infa Red?	Burg	Robotics Education and Curriculum	7	30-12-2004 12:31
How to connect the R/C receiver?!	Tim Skloss	Robotics Education and Curriculum	7	10-12-2003 16:34

All times are GMT -5. The time now is 20:44.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.