|
|
|
 For Pete's sake, don't concentrate on the entry itself... concentrate on what your team is doing to make an impact in your community. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| For Pete's sake, don't concentrate on the entry itself... concentrate on what your team is doing to make an impact in your community. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
06-01-2008, 14:23
|
|||||
|
|||||
|
Re: Reading gyro before Autonomous mode
Last year for our drive-by autonomous mode, we used a gyro on our arm to get the angle that we had to turn to. As soon as the robot was turned on, we set the code to initialize the gyro (which takes a few seconds) on our arm before autonomous started. As soon as the gyro is initialized, it would sit right around 0, but over long periods of time the default value can drift as much as 15 degrees over a two or three minute period.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gyro Autonomous Problems | cprogrammer | Programming | 5 | 23-03-2007 14:28 |
| How to end an auto mode after gyro gets out of deadband | kiettyyyy | Programming | 17 | 20-04-2006 07:59 |
| Reading switches during Autonomous | TimeOut | Programming | 3 | 19-02-2006 16:23 |
| Gyro not working in Autonomous? | kaszeta | Programming | 7 | 11-02-2006 01:28 |
| how can you use a gyro in autonomous mode | magical hands | Programming | 3 | 02-01-2004 13:31 |
Threaded Mode