|
|
|
 Yellow bananas are the new red herrings. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Yellow bananas are the new red herrings. - artdutra04 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Sensor Distribution Circuit Breaker
I am uncertain and unclear on this, but would it be "legal/allowable/permissible" to have a single 20AMP breaker for ALL the sensors on the Robot using a 12V supply.
In my case, the only sensors I have requiring a 12V supply are: I have 2 Gear Tooth Sensors drawing 16mA each (32mA total) I have 1 IR Board drawing 19mA I'd like to simply join the power and grounds together and connect them together at a single 20AMP breaker on the breaker panel. Or would I actually need an individual break for each? Thanks, Michael Last edited by Phalanx : 08-01-2008 at 10:38. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 12 volt sensor distribution breaker panel? | Uberbots | Electrical | 3 | 14-01-2006 23:31 |
| Cheap circuit breaker | krhs_programmer | Electrical | 11 | 23-02-2005 00:04 |
| 120 A circuit breaker | tbmantia | Electrical | 2 | 05-02-2003 12:30 |
| 120A Circuit Breaker | BrianB | Kit & Additional Hardware | 4 | 06-01-2003 14:02 |
| circuit breaker | archiver | 2001 | 2 | 23-06-2002 23:18 |
Threaded Mode