|
|
|
 Who said you'll WANT to avoid other robots in auto mode this year?:yikes: (Look at, say, 2006, 2007, 2004, 2003...) - EricH [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Who said you'll WANT to avoid other robots in auto mode this year?:yikes: (Look at, say, 2006, 2007, 2004, 2003...) - EricH [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Friction and Trackballs
I'm not sure if this is the right place to post this question, but here goes...
What have people found to be good for 'gripping' the trackball? Non-slip matting for drawers slides right off, and rubber wheels slip a bit, too. The tread from the InnovationFirst traction wheels grips ok, but not great... Ideally, we'd like to pick up the ball and hold it rather firmly -- so does anyone have any suggestions as to materials that will 'stick' to the polycanvas cover? Thanks! Patrick 1551 "The Grapes of Wrath" |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trackballs | chaineezee | General Forum | 67 | 25-01-2008 11:10 |
| Contact Area and its Relation to Friction? | Qbranch | Technical Discussion | 51 | 17-01-2008 09:31 |
| Bouncing TrackBalls | GBilletdeaux930 | Rules/Strategy | 22 | 09-01-2008 22:17 |
| Friction coefficients for Omni wheels and Mecanum wheels from AndyMark | Andy Baker | Technical Discussion | 11 | 16-12-2006 19:40 |
Threaded Mode