2 way IR communication?

neilcooper · #1 07-01-2008, 09:50

Is this allowed if its not intended to jam other robots?

Also would a multiplexer be a bad idea for it because it only runs at 100 ms?

interfect · #2 09-01-2008, 16:39

I think the rules basically lock you down to four static commands to the robot. So no magic fancy control systems are allowed. I'm not sure what you'd use two-way communication for, but I don't think you can have it.

RyanN · #3 09-01-2008, 16:44

Send commands to the OI for it's LEDs, get the drivers to relay stuff to the robotcoach. The OI is able to receive information during autonomous.

interfect · #4 09-01-2008, 16:47

If you really need to get info to the robocoach, put some big lights on top of the robot.

Alan Anderson · #5 09-01-2008, 20:14

Check the manual for answers to this and other questions.

Quote:

Originally Posted by <R65>

SIGNALING DEVICES shall:...not receive any input or feedback directly from the ROBOT (the ROBOCOACH may receive feedback from the ROBOT and use it to control the SIGNALING DEVICE)

Two-way IR communication would violate this rule.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Data Communication	coreyk	IT / Communications	4	02-05-2005 19:09
pic: Another one from way, WAY up	CD47-Bot	Extra Discussion	18	01-05-2004 02:31
Section 2 - Communication	team222badbrad	General Forum	2	08-01-2004 20:03
Serial Communication in C++	Adam Shapiro	Programming	8	21-01-2003 12:49
organized way of communication with FIRST?	archiver	2001	0	24-06-2002 04:20