|
|
|
 You do use CAD to prototype, Cardboard Aided Design. - Peter Matteson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You do use CAD to prototype, Cardboard Aided Design. - Peter Matteson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Robot Science & Technology
Posted by Kate.   [PICTURE: SAME | NEW | HELP]
Engineer on team #190, Gompei, from Mass Academy of Math and Science and Worcester Polytechnic Institute. Posted on 10/22/99 4:20 PM MST Hi all.. I just wanted to let everyone know that there is another article about FIRST in the Robot Science & Technology magazine.. It's the September/October 1999 issue (sixth).. It's a very good article.. I suggest you find it and read it sometime.. =) -KATE- |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much planning goes into your robot? | Jnadke | General Forum | 41 | 29-01-2006 21:29 |
| Full list of teams & competitions | archiver | 2001 | 14 | 24-06-2002 00:52 |
| WASH Palm scouting at the Championship | Mike Soukup | Scouting | 2 | 19-04-2002 15:14 |
| Index of team's post about their robot... | Ken Leung | Robot Showcase | 1 | 20-03-2002 17:10 |
| about how Drive Train push the robot... shouldn't the force accelerate the robot? | Ken Leung | Technical Discussion | 12 | 26-11-2001 09:39 |
Threaded Mode