roll pin into output shaft

10-01-2008, 16:30

m1k3

Registered User

FRC #1396

Join Date: Dec 2006

Location: new york

Posts: 23

m1k3 is an unknown quantity at this point

roll pin into output shaft

hey guys we are trying to put the roll pin into the output shaft but we cant seem to get it in we tryed expanding the metal with heat ,oil and we already broke 2 of the roll pins we cant get it in Any other temas having problems with this

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Beware - transmission output shaft is not 5/8"!	jskene	Kit & Additional Hardware	30	13-02-2006 14:01
diameter of transmission output shaft	sj31419	Electrical	5	17-02-2005 22:09
Cutting the output shaft	Kevin A	Technical Discussion	2	18-02-2003 01:47
Securing hex shaft to drill output	D. Gregory	Technical Discussion	6	24-01-2003 14:05

All times are GMT -5. The time now is 18:17.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.