|
|
|
 I design gears and gear boxes for a living. I am HAPPY to write a check and have a solution in mailed to me. - Joe Johnson [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I design gears and gear boxes for a living. I am HAPPY to write a check and have a solution in mailed to me. - Joe Johnson [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
10-01-2008, 21:16
|
|||||
|
|||||
|
Re: Mounting two output sprockets on andyMark :confused:
There is enough room to fit two 3/4" width sprockets on the output shaft. If you do need a longer shaft, AM does not supply a longer shaft for the toughbox. However, if you purchase the single speed 2" longer shaft and work the short end down from 1/2" to 3/8" with a lathe (its unhardened steel) the shaft is pretty much identical to that supplied with the toughbox... except longer.
Make sure when purchasing a second set of sprockets to buy with a spline... we need to broach ours now. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Confused Mentor | Stu Bloom | Chit-Chat | 18 | 05-02-2007 08:44 |
| Mounting encoders to the AndyMark | Joel J | Technical Discussion | 11 | 31-01-2007 21:32 |
| Totally confused | Justin Brooks | Pneumatics | 2 | 16-01-2007 15:22 |
| mounting andymark wheels | VEN | Technical Discussion | 10 | 04-02-2006 00:14 |
| Putting two and two together... | Andy Grady | General Forum | 13 | 08-01-2004 18:29 |
Threaded Mode