|
|
|
 BEING a chairmans team is alot more important then WINNING the chairmans award. - fuzzwaz [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| BEING a chairmans team is alot more important then WINNING the chairmans award. - fuzzwaz [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
10-01-2008, 23:44
|
|||||
|
|||||
|
Re: shafts for wheelbearings
You have to provide your own axle to mount the wheels on. The easiest solution would be bore out the kitbot holes and use Grade 8 1/2" bolts. There are already a couple other threads on here about this so you can take a look for more details on the other ideas (turning down shafts ect.)
|
|
#3
10-01-2008, 23:49
|
||||
|
||||
|
Re: shafts for wheelbearings
We go to the hardware store and buy a length of 1/2 by 3/8 bore steel tubing and cut it to length as sleeves over the 3/8 bolts.
not so elegant but works. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: sprockets&shafts | steve0o | Extra Discussion | 7 | 08-02-2007 17:39 |
| [OCCRA]: Modifying Shafts | tdlrali | OCCRA Q&A | 1 | 30-09-2006 14:08 |
| Torsional Deflection of shafts? | coreyjon | Technical Discussion | 3 | 21-01-2005 19:02 |
| What is your favorite method for attaching gears to shafts? | archiver | 2001 | 13 | 24-06-2002 04:00 |
| 5/16" cold steel shafts... | archiver | 2001 | 3 | 23-06-2002 23:17 |
Linear Mode
