|
|
|
 Friends don't let friends drive mecanum. Enough said... - Botsup [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Friends don't let friends drive mecanum. Enough said... - Botsup [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
geer tooth sensor - how many will code support?
Using the gear tooth sensor, how many can encoder the code support? I am unsure how many external interrupts exist on this chip...
Last edited by RedOctober45 : 10-01-2008 at 23:00. |
|
#2
10-01-2008, 23:21
|
|||||
|
|||||
|
Re: geer tooth sensor - how many will code support?
Quote:
|
|
#3
10-01-2008, 23:38
|
|||
|
|||
|
Re: geer tooth sensor - how many will code support?
Ok, I understand, thanks!
|
|
#4
13-01-2008, 14:33
|
||||
|
||||
|
Re: geer tooth sensor - how many will code support?
to make things easier, use Kevin's encoder code (kevin.org/frc) and just modify the Phase-B out of it.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to integrate Gear Tooth Sensor | magical hands | Programming | 0 | 18-02-2007 17:43 |
| Gear Tooth Sensor? | Raikon | Kit & Additional Hardware | 3 | 09-02-2007 16:40 |
| Gear Tooth Sensor | Talha | Electrical | 1 | 23-01-2006 21:29 |
| LabView Gear Tooth Sensor Code | SkiRacer | LabView and Data Acquisition | 2 | 17-01-2006 03:53 |
| How many will fit? | Joe J. | General Forum | 1 | 15-01-2004 15:17 |
Linear Mode
