Wiring pressure switch

[m1k3]

do you soder the pwmto the prongs

[Al Skierkiewicz]

Originally Posted by m1k3

do you soder the pwmto the prongs

Use a crimp connector on the end of the PWM cable that attaches to the switch. Since the PWM cable is #24 wire or smaller, simply strip back about an inch of the insulation and fold the wire over twice. This will give you an equivalent wire size somewhere between #18 and #22, just the right size for a small crimp.
Never solder to the RC, use the female RC connector supplied with the PWM cable.