|
|
|
 Advances in STEM are meant to benefit everyone, so even the most basic-level of understanding deserves to be validated and encouraged. - moamomen [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Advances in STEM are meant to benefit everyone, so even the most basic-level of understanding deserves to be validated and encouraged. - moamomen [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#22
11-01-2008, 15:33
|
||||
|
||||
|
Re: Springs?? (10 lbs. at 22 ft/s)
What if you were the inspector, what would you be looking for?
How secure is the spring attached to the robot? How secure is the launching pad between the trackball and spring? What has been done to protect against pinch points between the launcher and robot? These are just a few of the questions I would have (not and inspector). What other ones could you ask. Aside: Putting your robot on display (grade schools, sponsors etc) will be a riot if you can hurdle the trackball 7-8 feet in the air! The only problem will be getting that blasted 41" trackball through a standard door. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 240 lbs against wall! | falconmaster | Extra Discussion | 10 | 28-01-2007 13:21 |
| pic: 7 lbs overweight | CD47-Bot | Robot Showcase | 9 | 23-04-2004 02:27 |
| Rambot weighing in at 72.5 lbs! | archiver | 2001 | 3 | 23-06-2002 22:04 |
Threaded Mode