|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: pic: Pulley?
It might help to know how big it is supposed to be, and what the requirements for it are...for example, does it need to be a specific width, or could be anywhere from 2" to 6" wide? does it need to have a specific diameter inside for the shaft, and outside for the cable/wire/whatever to roll onto? Is there some weight limit you have in mind? Do you have welding capability, or a shop in town that could weld steel or aluminum, if you could cut a tube and make the "washers" for the ends? and is there some other way to attach it to a shaft?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Team 48 Drive Pulley | A_Reed | Extra Discussion | 2 | 29-01-2007 12:26 |
| Large CIM motor pulley size/series? | Tim Skloss | Technical Discussion | 3 | 09-01-2007 22:36 |
| big CIM pulley | Rickertsen2 | Motors | 1 | 18-01-2006 11:41 |
| Timing Belt and Pulley | Joe_Widen | Technical Discussion | 4 | 16-01-2006 13:41 |
| Gear and Timing Pulley Design Resources | Madison | Technical Discussion | 2 | 08-05-2003 21:01 |