|
|
|
 "Professionalism at all times... even when you're playing an epic prank on your friends." - JVN [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| "Professionalism at all times... even when you're playing an epic prank on your friends." - JVN [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
12-01-2008, 21:54
|
|||
|
|||
|
Re: How to conect solenoids to the circuit board. and how to program it...???
To connect the solinoids you will need a spike. The black which is ground (negative) connects to the circuit breaker panel where it says negative and the red connects to the same panel but to a 20 amp breaker not fuse. The m+ and m- on the spike is where you connect the solinoid. I believe that you take a black wire from one side of the solinoid and a red wire from the other side and put a connector to it, do the same for the other two. Also the programming for it is the default code which i believe uses relay outputs 2&3. Not sure on that one but this stuff should help you.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to program ir sensor board?? | RRA4LIFE2 | Programming | 1 | 11-01-2008 21:47 |
| how to assemble the solenoids | MNov | Pneumatics | 2 | 09-01-2008 00:02 |
| How fast does the Solenoids turn on and off? | Generalx5 | Robotics Education and Curriculum | 2 | 26-01-2007 01:09 |
| Anyone know how fast the Solenoids on the MINI RC can turn on and off? | Generalx5 | Control System | 1 | 06-01-2007 07:39 |
| Does anyone have an idea on how to make a joystick program for an operating board? | necroprime | Programming | 8 | 09-11-2002 19:04 |
Threaded Mode