|
|
|
 My rule of thumb is that any team who's won four World Championships can count their chickens whenever they want. :p - Karthik [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| My rule of thumb is that any team who's won four World Championships can count their chickens whenever they want. :p - Karthik [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
13-01-2008, 11:45
|
||||
|
||||
|
Re: Help with Inventor Files of Toughbox Mounting
After mounting the Toughboxes onto the frame, I've noticed a few issues for our design. Compared to the Banebots long shaft to bearing blocks from last year, the Toughboxes have 1.658" output shaft. We only have room for one 15 tooth sprocket (0.75 " shaft side width) due to aligning the chain with either side of a 1" AndyMark Wheel.
The next best option for four wheel drive is to route a chain (or belt) from the connected wheel to the next wheel. I have two questions. What are simple ways to extend the output shaft ? (shaft couplers , using the 1/4-20 threads ... etc. ) Can the Toughbox operate effectively without a supporting bearing block on the standard output shaft ? Last edited by lynca : 13-01-2008 at 11:47. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toughbox mounting bracket models | Rob | CAD | 2 | 10-01-2008 11:34 |
| help with the inventor[robot part missing] (ajuda no inventor[parte do robo faltando] | team 2244 | Inventor | 6 | 12-02-2007 06:16 |
| Converting step files to inventor files | GMAdan | Inventor | 4 | 01-01-2007 20:09 |
| Help with Files | tawnos484 | Programming | 4 | 20-01-2006 03:40 |
| Can you use inventor files with 3DS Max? | Ydnar | Inventor | 4 | 10-01-2002 14:23 |
Threaded Mode