|
|
|
 I saw 2274, a rookie team that had won the regional, gathered around their mentor. He was holding their trophy and saying, "This is what it is all about. Teamwork and cooperation. You guys did great." - Po-ser [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
IR Problems
I just started playing with the IR sesnor and i have some probelms.
When i enter 'Learn' mode and press a button on my remote control, the COM0 led turns off, and the error led turns on. After that it goes to the COM0 again, i press the same button and once again the ERROR led is on. Same repeats with COM1, 2 and 3. Any ideas what should i do to overcome this issue? I am using a univeral remote controller. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview problems and code problems | ajsetter | Programming | 25 | 18-01-2006 17:07 |
| Problems | muy dificil | Programming | 5 | 26-10-2005 17:10 |
| Problems- | archiver | 1999 | 0 | 23-06-2002 23:00 |
| Problems- | archiver | 1999 | 0 | 23-06-2002 23:00 |
| Problems, problems . . . | archiver | 2000 | 6 | 23-06-2002 23:00 |
Threaded Mode