|
|
|
 I find it quite amazing that this thread has been continuously active for more than two years. - Stephanie [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I find it quite amazing that this thread has been continuously active for more than two years. - Stephanie [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
IR programming and wiring difficulties
Hey everyone i have a few questions that i would like to ask.
FIRST of all......i want to make sure that the IR wires should be plugged into the signal pin of the digital input robot controller. I run easy C and when i run the terminal program on it, it tells me that the robot is sensing the ir sensor but all the inputs are always at one, and then when you press one of the ir buttons it changes the three that aren't being used to zero. Is this what is suppose to happen?? i also haven't been able to get the robot to respond with any of my programs can somebody give me an example program to work with to make this right??? thanks for all the help Adam (progammer) |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Programming in Python and Explaination of Programming | roboxking | Programming | 22 | 07-01-2008 16:08 |
| Need help Programming and wiring camera! | Amisca | Programming | 1 | 14-02-2006 18:37 |
| I'm having difficulties locating the programming code "gift" | Flynn | Programming | 3 | 09-01-2005 22:01 |
| Team issues and difficulties?....(not just technical ones) | tribotec_ca88 | General Forum | 40 | 11-02-2004 10:36 |
| Pneumatics electrical wiring and programming | archiver | 2001 | 1 | 23-06-2002 23:10 |
Threaded Mode