IR Programming Problems

team877 · #1 13-01-2008, 19:59

We have it hooked up correctly and our easyc program reads it correctly but we can not figure out how to use the boards pulse signal to make our robot do functions.

tseres · #2 13-01-2008, 20:04

if(DIGITAL_PIN){
do_what_you_want_the_robot_to_do();
}

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mecanum drivetrain programming problems	Mr. Freeman	Programming	4	21-03-2007 17:11
problems programming knob and switch	caderader	Programming	4	16-02-2006 16:45
Problems with Programming	DHarris	Programming	4	16-02-2006 13:08
Problems programming a switch	caderader	Programming	2	18-02-2005 22:06
Programming Sub-Team Problems	Phil Paspalas	Programming	9	19-01-2005 21:42