Filtering out Vibration while using a KOP Accelerometer

.....just don't hurt the programmer =) - mtaman02 [more]

		Chief Delphi > Technical > Electrical
Filtering out Vibration while using a KOP Accelerometer

Thread Tools

Rate Thread

Display Modes

13-01-2008, 22:25

joshyboy9987 joshyboy9987 is offline

Registered User

FRC #0706

Join Date: Jan 2008

Location: Hartland, WI

Posts: 16

joshyboy9987 is an unknown quantity at this point

Re: Filtering out Vibration while using a KOP Accelerometer

Hmmm... The design team is gonna have a fit if I tell them to put an extra wheel on the robot, maybe I'll just make 'em deal with it.

But if I was to use an accelerometer, any ideas on how to make it work? The spec sheet says to use filters, so I guess I'll try that, but otherwise I might have to add some extra hardware..

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
EMI Filtering	Mike Betts	Electrical	1	06-03-2007 15:38
Using camera PWM out	Cuog	Programming	2	28-11-2005 14:17
Hall effect sensor Filtering	magical hands	Programming	5	13-02-2005 11:23
Content Filtering	FRANK(WGH)	IT / Communications	1	23-10-2004 09:21
Using Accelerometer with '04 controller	sanddrag	Control System	4	20-02-2004 12:18

All times are GMT -5. The time now is 15:31.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.