|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Few Questions regarding IR board
Ok I understood that.
But there are 2 power cables and 2 ground cables. Should I connect every 2 cables to 1 leg on the PWM? And another thing: the digital I/O gives only 5 volts. The IR board needs at least 7, no? |
|
#2
|
||||
|
||||
|
Re: Few Questions regarding IR board
Yes, you are right in that it needs at least 7 volts. We are going to connect the power to a breaker (12V), and then connect outputs 0,1,2 to a PWM plug and three to another plug. The pwm plugs will be plugged in sideways so that all pins are on the "SIG" row of the digital inputs. (The row closests to the words "DIGITAL IN/OUT"
Brian |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Questions Regarding Rules | compasswilting | Rules/Strategy | 6 | 13-01-2007 14:56 |
| A few questions | Chase | General Forum | 15 | 14-08-2005 13:29 |
| A few questions... | Ryan Dognaux | 3D Animation and Competition | 3 | 19-02-2005 22:48 |
| A few questions | cheezewiz | Programming | 7 | 31-01-2004 00:02 |
| A few questions | goegan31 | Regional Competitions | 1 | 09-03-2003 20:32 |