|
|
|
 The point of FIRST is to get a wide range of kids together and have them work as a TEAM. - Firewolf [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The point of FIRST is to get a wide range of kids together and have them work as a TEAM. - Firewolf [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Andy Mark Traction Wheels?
Go with the IFI traction wheels. We used 6 of them last year and had more traction and power than in any previous year. It was a bit too much traction though; we ended up flipping over the tread on the two front wheels so it was able to turn.
|
|
#2
15-01-2008, 11:58
|
|||
|
|||
|
Re: Andy Mark Traction Wheels?
thank you all of you guys!
we did some research, and found that the IFI traction wheels were our best bet, so we ordered two of them (only for drive wheels). We have the funds to spend on wheels, as our goal is to get the best possible rolling frame we can, and do all the technical do-dads afterwards, if they're even needed. Again, thank you guys very much! |
|
#3
15-01-2008, 13:09
|
||||
|
||||
|
Re: Andy Mark Traction Wheels?
Word of advice: Take your time and make sure you have the EXACT size for tools to screw stuff in. Some of our screws started stripping too easily due to a bad assembly tool & process. We've used IFI tractions for 2 years + this year -- they work great.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Andy Mark Battery Plugs | Fab.Master | General Forum | 0 | 05-01-2008 22:44 |
| Andy Mark AM servo shifter (GEN 2) | robotguru1717 | Motors | 1 | 25-01-2007 20:23 |
| pic: Andy and Mark visiting IFI | Andy Baker | Chit-Chat | 7 | 22-01-2007 16:39 |
| Andy Mark Transmissions Drawings | vVigglEs | Inventor | 8 | 18-01-2007 20:08 |
| Andy Mark Planetary + side load | Salik Syed | Motors | 10 | 30-01-2006 21:53 |
Hybrid Mode
