|
|
|
 FIRST is definitely worth any amount of money any company gives. FIRST really puts on good events for us, and I can see where the money is going. - RBrandy [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is definitely worth any amount of money any company gives. FIRST really puts on good events for us, and I can see where the money is going. - RBrandy [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
14-01-2008, 19:53
|
||||
|
||||
|
Re: Wiring the IR sensor board
use either 1 or 2 and 3 or 4 for power supply. the other ones (look at the documentation because i don't have it with me right now) are the outputs. the outputs can get hooked up to the digital in side of the rc, each of them a signal wire. You need to ground all of them though. out setup is in an L shape, with the base of the L the ground and one signal and the upright part 3 more signal wires. we just just pwm cables for this. it works well enough for testing purposes
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need tips on wiring the IR board | Bryan Herbst | Control System | 4 | 12-01-2008 18:34 |
| Wiring for the allegro gear sensor | mechanicalbrain | Electrical | 4 | 19-02-2006 17:03 |
| The Hall Effect sensor wiring? | LaughingJack | Electrical | 11 | 21-02-2005 13:35 |
| wiring the optical sensor | bob1million | Electrical | 2 | 24-01-2004 11:00 |
| Optical sensor wiring with the EDU Robot | Geoffrey4283 | Electrical | 3 | 15-01-2003 21:03 |
Threaded Mode