|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||
|
||||
|
Re: Can you apply an assembly extrusion to a part?
When you sketch the new sketch on the part you dimension the sketch. Then you turn on the visability of the dimensions on on the end of the sketch.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can the VEX controller be programmed in assembly? | Capt. Quirk | Programming | 7 | 23-12-2007 09:31 |
| Assembly to Part | Zoheb N | Inventor | 8 | 07-02-2007 01:26 |
| Can we use part of a container on our robot? | Rick | General Forum | 1 | 10-02-2003 20:10 |
| Can I reduce the number of similar part files? | roknjohn | Inventor | 2 | 29-01-2003 21:36 |
| How much can the window assembly lift? | archiver | 2000 | 9 | 23-06-2002 22:59 |