|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: weight distribution
If you're not going to have any ball handling "stuff" on the robot, then you probably want to make it as low as possible (remember you'll need a part that sticks up 51" to mount the flag).
We're trying to get our center of gravity (to use the old term) as low as possible, centered on the robot front/rear, and to the left side of the robot as much as practical. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Weight? Estmate weight? | Arkorobotics | General Forum | 21 | 29-01-2007 17:34 |
| Wait...weight...weight!!!! | Greg Perkins | General Forum | 3 | 22-02-2006 07:42 |
| weight distribution? | chrisw | Technical Discussion | 3 | 11-01-2003 13:25 |
| Weight Distribution Mechanism in Tread System? | Kai Zhao | Technical Discussion | 8 | 20-08-2002 16:38 |
| Weight Distribution Question | Eric Reed | Technical Discussion | 7 | 19-02-2002 06:08 |