|
|
|
 It's not about taking risks, but more about identifying them (which is the hardest part) and reducing them. - Deke [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It's not about taking risks, but more about identifying them (which is the hardest part) and reducing them. - Deke [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: pic: Wheelie Bar
Good to see you are thinking about the comments from your last picture! I wonder where that one came from?
 and as mentioned, make sure it still fits the 80" rule.... 
|
|
#2
17-01-2008, 12:42
|
||||
|
||||
|
Re: pic: Wheelie Bar
I'd like to know what this press fit stuff is. I couldn't find it under press-fit alunimium.
How about a part number so we can check this stuff out? Or is it the same as Faztek/80-20 extrusion stuff? Thanks R3P0
|
|
#3
17-01-2008, 13:38
|
|||
|
|||
|
Re: pic: Wheelie Bar
warning!!!!
wheelie Bars are always nice to help stop flipping but if another robot gets stuck or damaged because of them you might be penalized take it from me its happened to us Last edited by xcarmichael65x : 17-01-2008 at 13:53.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 4 robots on the bar | CD47-Bot | Extra Discussion | 11 | 21-03-2004 10:55 |
| pic: 4 on the bar | CD47-Bot | Extra Discussion | 4 | 18-03-2004 10:32 |
| pic: Hanging on the bar | CD47-Bot | Robot Showcase | 4 | 25-02-2004 22:29 |
| SwampThing wheelie-bars at UCF | Tytus Gerrish | Regional Competitions | 0 | 14-10-2003 22:54 |
| pic: Under the bar | CD47-Bot | Extra Discussion | 2 | 16-03-2003 22:38 |
Hybrid Mode
