pic: 973 finished parts

17-01-2008, 12:38

redbarron

Mike Barron

AKA: Mike

FRC #1270 (Red Dragons)

Team Role: Coach

Join Date: Jan 2004

Rookie Year: 2002

Location: Cleveland, Ohio

Posts: 187

Re: pic: 973 finished parts

Actually if you took the zero at one end and then set the other end as your zero when done with the first side you are relying on the fact that your piece is to exact length, which in most cases is not too critical but if they are saying the tolerances are tight than you probably want to just indicate off a hole on the first side you did and work off of that...... Are these part of the frame?

__________________
The Red Dragons
2005 Buckeye Regional Woodie Flowers Regional Award
2005 Florida Regional Finalist Along with 1251 and 845
2006 Palmetto Regional Engineering Inspiration Award
2007 Florida Regional Judges Award and Regional Winners Along With 1251 and 86
2007 Curie Division Winner with 330 and 910
2008 Florida Regional Team Spirit Award Winners

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: 973 teaser #2	AdamHeard	Extra Discussion	10	11-01-2008 22:55
pic: Possible 973 Teaser	AdamHeard	Extra Discussion	18	11-01-2008 21:00
pic: 254/968 Finished Parts	Cory	Extra Discussion	9	08-01-2008 10:04
pic: 968 - Plenty of finished parts!	Travis Covington	Extra Discussion	5	01-02-2007 02:10
pic: 968 - A few finished parts!	Travis Covington	Extra Discussion	26	24-01-2007 08:02

All times are GMT -5. The time now is 22:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.