Omni Wheel

Taylor · #1 17-01-2008, 17:21

We make an aluminum part that holds the bearing in. This goes over the lipped side, holding it to the omniwheel.

roborat · #2 17-01-2008, 18:15

We just made spacers to go between the bearings and the frame on both sides.

vivek16 · #3 20-01-2008, 22:58

Quote:

Originally Posted by boiler

We make an aluminum part that holds the bearing in. This goes over the lipped side, holding it to the omniwheel.

haha, that was pretty much our approach. Except we just used some scrap aluminum sheet and the hand mill and only had three holes. your's looks nicer though

-vivek

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Poor Man's Omni Wheel	Sean Schuff	Extra Discussion	11	24-01-2006 22:48
omni wheel instead of mecanum wheels	Leav	Technical Discussion	4	15-01-2006 18:53
Omni-Wheel Design	fightoplankton	Technical Discussion	7	08-01-2006 23:49
pic: Dual omni-wheel	Richard Wallace	Extra Discussion	17	05-12-2005 10:38
Omni wheel supplier	JamesBrown	Technical Discussion	5	25-02-2005 13:27