|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
Re: Custom IR Board
To use a TV remote you need a special IR receiver that will recognize the 38.5 KHz modulation. The output of that IR receiver will be the pulse train that you send out from the TV remote control or equivalent device you build. They are easy to find - Parallax sells such a receiver at low cost. Connections are simple with three pins: +5v, ground and pulse out.
The FIRST IR board uses such a receiver. Note: the special receiver is much different that the analog approach using an IR LED and an IR sensitive photo detector. Cheers, Larry |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Custom Pneumatics - Control Board Selection? | Erin Rapacki | Electrical | 3 | 03-04-2007 17:21 |
| Lights in Joystick board or control board | rcubes85 | Control System | 15 | 26-02-2005 23:40 |
| Using Custom Inputs on the Controller Board | schenkin | Programming | 10 | 27-01-2005 10:26 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
| custom titles | shyra1353 | CD Forum Support | 7 | 28-12-2003 11:52 |