|
|
|
 FIRST has changed my life and I can never say thank you enough. - Jason Kixmiller [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST has changed my life and I can never say thank you enough. - Jason Kixmiller [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
18-01-2008, 16:16
|
|||||
|
|||||
|
Re: General Question About Pneumatics
The pressure switch is a sensor, so it cannot be used to directly control a relay. You have to connect the pressure switch to a controller input (using a PWM cable with ring terminals soldered/crimped to the ends of it), and connect the spike to the controller output.
You need to download the pneumatics manual and read it a few times to help you understand all that other stuff. http://www.usfirst.org/community/frc...nt.aspx?id=452 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help With General Pneumatics | Ryan O | Programming | 7 | 24-01-2007 21:31 |
| General question about the robot controller | itsme | Technical Discussion | 6 | 14-01-2007 15:33 |
| General programming question | mikesown | Programming | 1 | 07-02-2005 16:09 |
| General Pneumatics | Drok00 | Pneumatics | 8 | 11-01-2005 23:35 |
| Question about the animation in general... | Devil's Kid | 3D Animation and Competition | 5 | 22-01-2002 12:34 |
Threaded Mode