|
|
|
 I'm unconvinced that this thread itself is not a performance art piece. - DCA Fan [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm unconvinced that this thread itself is not a performance art piece. - DCA Fan [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
19-01-2008, 12:53
|
||||
|
||||
|
Re: Cable for forklift mechanism
It depends on your lifting mechanism and the load. One year, we used 3/16" or 1/4" nylon rope to operate a list mechanism. Another team used some nylon strap webbing, perhaps 1 inch wide by 1/16" thick. That stuff spooled up nicely.
|
|
#3
19-01-2008, 13:51
|
||||
|
||||
|
Re: Cable for forklift mechanism
the best solution we have found are the gates belts, they work great (although pricey) and can hold and move a large load with minimal stretch. verry fast to put together as well
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motor for a forklift | calvin1631 | Motors | 7 | 10-01-2008 11:30 |
| Cable/winch vs. chain for telescopic arm | VEN | Technical Discussion | 9 | 20-01-2007 22:37 |
| Bluetooth replacement for programming cable? | EHaskins | Programming | 13 | 26-07-2006 03:50 |
| What kind of material will you be using for your arm/forklift? | Atman | Technical Discussion | 35 | 31-01-2005 15:28 |
| PWM Cable Clip for Victors | sanddrag | Technical Discussion | 9 | 18-07-2004 19:27 |
Hybrid Mode
