|
|
|
 Remember that starting a team is ALOT of work, but it’s a lot of fun once it gets going. Its all about the students, so don’t get too carried away ;) - Travis Covington [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Forklift Materials
Aluminum C-channel, I think around 1.5" wide x 1" deep with 1/8" thickness. (Might be 1"x1", same thickness.) Fasten the top and bottom of each stage together with plate. It's strong enough to take the full weight of a robot on a three-stage lift--and cable-run, in my experience. Even with holes in the C-channel on the wide side, never had a serious material problem.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FORKLIFT HELP? | t41w4ne5ef0b | General Forum | 12 | 20-01-2008 18:24 |
| Forklift help!!!!!! | The_Laughing_ManMII | Technical Discussion | 7 | 14-01-2008 17:17 |
| Motor for a forklift | calvin1631 | Motors | 7 | 10-01-2008 11:30 |
| Forklift | FRC1710 | Technical Discussion | 14 | 08-01-2008 12:51 |
| pic: Forklift Surprise | triggerhappy336 | Extra Discussion | 1 | 18-04-2007 12:04 |
Hybrid Mode
