Power connections for Keyang motors

[aeasson]

Does anyone know where to get the power connectors for the Keyang motors?

Or do we just break off the plastic around the contacts and fabricate our own style connector.

[Jim E]

They were supplied in the KOP. You will have to attach wires to the pins .

See section 10.2.5.10 in the KOP REV A .pdf for a picture of what they look like.

[Zoysiamo]

There is only a connector for the 16627960 (or 61), the KoP checklist misleadingly shows two connectors.
See section G.5.2 DC Motors, "Special Notes on Motors"
http://www.usfirst.org/uploadedFiles...nes%20RevB.pdf
Hope this helps, it took us a while to figure out that we have to make our own connector for the 16631023 Keyang.

[esisso]

i believe you can get one at a junkyard, but its a lot easier to dremel off the plastic and make your own...we've done that in the past

[TubaMorg]

We just got rid of the plastic around the connector and soldered a pigtail on (plus heat shrink tubing).

[neoshaakti]

does anyone have any pictures they can share?

[esisso]

here you go



from our 07 bot

[The_Ravioli_Man]

a mentor and I just went to some local autopart stores to see if we could find the right hook-up for the -023 motor and we believe we found a match. If you all still need to find this part, go to your local autopart store and tell them part number EC86, it looks very, very, very close to the hook-up required for it.

Just thought I would let everyone else know in good sportsmanship