|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Kitbot Endcap Problems
The Endcap that I downloaded has a "solid" back plate. I need to have two holes on each side in order to make constraining easier for me. Does anyone else have this problem? Thanks in Advance. There is an attachment that might show what i mean.
|
|
#2
|
||||
|
||||
|
Re: Kitbot Endcap Problems
I might be missing the problem, but couldn't you just add the holes? If you put them in right it won't even be visible.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| KITBOT assmenly | Tottanka | General Forum | 4 | 10-01-2008 23:30 |
| kitbot stuff..? | naroarr | Inventor | 1 | 17-01-2007 16:59 |
| Kitbot chassis in Pro/E | Billfred | Inventor | 1 | 27-02-2006 22:19 |
| Tips for KitBot | generalbrando | Kit & Additional Hardware | 15 | 15-01-2006 21:15 |
| Kitbot transmission plate | Andrew Schuetze | Technical Discussion | 9 | 30-01-2005 14:34 |