Programming the IR

Pi Boy · #1 20-01-2008, 20:22

Sorry if this question might have been asked before, but just for reference, what programming language do you use for the infrared Sensor?

Branden Ghena · #2 20-01-2008, 20:25

I'm pretty sure you aren't allowed to program the sensor itself, you normally just program the robot to react to the digital signals it outputs.

Alan Anderson · #3 20-01-2008, 21:33

Quote:

Originally Posted by Pi Boy

Sorry if this question might have been asked before, but just for reference, what programming language do you use for the infrared Sensor?

When someone refers to "programming" the IR sensor board, they're probably talking about teaching it to recognize signals. That's done by following the directions in the FIRST IR User Guide.

Pi Boy · #4 21-01-2008, 15:47

thanks a bunch, I wonder why I couldn't have found that sooner....:/

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
programming the pneumatics	Armando	Programming	2	17-02-2007 21:47
Programming the vex microcontroller to respond to commands on the serial port	crashoverride02	Programming	1	20-10-2006 14:17
Programming The CMUcam for the Vex controller	987HighRoller	Programming	3	24-06-2006 15:27
Programming the IR	James Hine	Programming	1	10-03-2004 14:08
programming the compressor	archiver	2001	4	23-06-2002 23:19