|
Re: Choice of Drivers
Posted by Rick Gibbs.
Engineer on team #145, T-Rx, from Norwich High School, Sherburne-Earlville High School and Procter & Gamble Pharmaceuticals.
Posted on 1/18/2000 8:07 AM MST
In Reply to: Choice of Drivers posted by colleen on 1/15/2000 10:33 PM MST:
I'm glad that we're not the only team out there that gets little to no practice time at the end of the six weeks.
We do something that I haven't seen mentioned yet here. The first things that the controls team does is to get last year's robot running on this year's control system. Then we have driver try-outs ASAP. The selected drivers then (ideally) perform all functionality tests, etc. during development. Seems to work out well.
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.
|
So yeah, everyone please remember that lathes are one of the most dangerous machine tools you'll encounter. And keep your hand on the chuck key whenever it's in the chuck. If you never let it go till it's out of the chuck, it's stupendously less likely to take flight. - Kevin Sevcik [more] 
23-06-2002, 22:36
Similar Threads
Threaded Mode