|
|
|
 We like playing with power tools, stripping wire, or just stripping for alliance partners... - Amanda Morrison [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We like playing with power tools, stripping wire, or just stripping for alliance partners... - Amanda Morrison [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Gear tooth sensor not driving to ground
Hi. We hooked our gear tooth sensor to an USB oscilloscope and while its putting out a square wave, its not driving to ground. It ranges from 3.8 to 3.9 volts when plugged into digital input 1. And yes, digital i/o 1 is set as an input in code. If I unplug it from the robot controller. It puts ranges from ground to around 1.4 volts. Probably because it doesnt have 5V then.
Could the sensor be bad? Brian |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gear Tooth Sensor | marco_alchemy | Electrical | 7 | 06-02-2008 09:54 |
| Gear Tooth Sensor | Zoom | Programming | 46 | 22-01-2008 08:05 |
| Gear Tooth Sensor | Nathan | Programming | 4 | 12-01-2008 15:09 |
| Gear Tooth Sensor? | Raikon | Kit & Additional Hardware | 3 | 09-02-2007 16:40 |
| Gear Tooth Sensor | AMIRAM | Electrical | 2 | 22-01-2006 04:09 |
Threaded Mode