|
|
|
 Weight down low is a good thing. Weight up high is not. - s_forbes [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Weight down low is a good thing. Weight up high is not. - s_forbes [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Question about the Pressure Switch
hey,
Our Pressure switch stops at 110psi. Any idea why? Thanks, Last edited by Bomberofdoom : 24-01-2008 at 15:11. Reason: was not me who mispelled at first post |
|
#2
24-01-2008, 09:23
|
|||||
|
|||||
|
Re: Question about the Pressure Switch
The pressure switch is not terribly accurate. That being said, it should allow your system to reach in the 120-130 PSI range. It might be defective and would then need to be replaced.
|
|
#4
24-01-2008, 11:00
|
|||
|
|||
|
Re: Question about the Pressure Switch
ours has always tripped at 110 - 115 psi indicated pressure. We run the compressor 5-7 seconds longer to reach 120 (programming).
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pressure switch wiring question... | Transformers | Pneumatics | 11 | 16-02-2008 12:55 |
| what is the pressure switch? | Reaper40 | Pneumatics | 2 | 25-01-2007 18:52 |
| Pressure Switch Wiring Question | Matthew_H | Electrical | 4 | 16-02-2004 01:25 |
| Pressure Switch Wiring Question | Matthew_H | Control System | 1 | 08-02-2004 15:28 |
| Question about Pressure Switch | Randy_Ai | Technical Discussion | 1 | 30-01-2002 18:29 |
Linear Mode
