|
|
|
 its like the championship being ice cream, its pretty awesome
IRI is like adding toppings, making it even more awesome - Aren_Hill [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| its like the championship being ice cream, its pretty awesome
IRI is like adding toppings, making it even more awesome - Aren_Hill [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
24-01-2008, 13:17
|
||||
|
||||
|
Re: Banebots 1/2" shaft encoder for Toughbox?
We used them last year with the Banebots. I can not remember off hand how we mounted them. Which probably means it was fairly easy. The only downfall that I remember was that the encoded ring gets glued to the shaft. Luckily with our self made double d plates we did not have to replace the Banebots. We were concerned that removing it from the shaft would damage it if we needed to replace the Banbots.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2008 Toughbox vs. Banebots vs. 2006 Gearbox | team 2191 | Technical Discussion | 5 | 20-01-2008 15:20 |
| BaneBots Encoder Chip # | whytheheckme | Electrical | 1 | 18-02-2007 16:36 |
| shaft encoder help | stephenthe1 | Programming | 2 | 03-12-2004 16:09 |
| Wiring "3-pin" Shaft Encoder. | Joel J | Programming | 7 | 27-02-2004 17:21 |
| supplier for 5/8" shaft | david.clark | Kit & Additional Hardware | 2 | 17-01-2004 18:13 |
Threaded Mode