|
|
|
 Oh, for the love of cod, can't you see that Dave is messing with us just for the halibut? When the actual clue comes out, I'm sure we'll all be singing a different tuna. - Pat Fairbank [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Gear Tooth Sensor problem found
Apparently two resistors are switched on one of the gear tooth sensors in the KOP.
R3 and R4 are the ones....see the pics... http://www.chiefdelphi.com/forums/sh...6&postcount=21 So now we know what we have to do. The bad board in our case is the one that was cut off the end, that is, the one with J1 and J2, the board with J4 and J5 is good. But you should double check! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with 2008 gear tooth sensor | Larry R | Sensors | 27 | 18-02-2008 11:39 |
| Gear Tooth Sensor | Zoom | Programming | 46 | 22-01-2008 08:05 |
| Gear Tooth Sensor | Nathan | Programming | 4 | 12-01-2008 15:09 |
| gear tooth sensor connecting problem | nirty | Electrical | 2 | 23-01-2006 12:17 |
| Gear Tooth Sensor | AMIRAM | Electrical | 2 | 22-01-2006 04:09 |
Threaded Mode